According to regulations, starting from September 10 this year, all trucks and trailers registered shall be affixed with body reflective markings as required; trucks and trailers registered with a total mass of more than 3,500 kg shall be equipped with side rear guards as required.
Since October 20 this year, all trucks and trailers in use shall be affixed with reflective signs on their bodies as required. Since February 20, 2009, all trucks and trailers in use with a total mass greater than 3,500 kg shall be equipped with side rear guards as required.
The traffic control department hopes to use this measure to further enhance the safety protection of trucks and trailers, prevent and reduce road traffic accidents caused by collisions, and maximize the safety of traffic participants' lives and property.
【Related Links】
How to paste reflective logo?
●Paste position requirements
Reflective signs on the vehicle body shall be affixed to the surface of the vehicle body that is unobstructed, easy to see, flat, continuous, free of dust, water, oil, rust, and paint.
Before pasting, wipe off the dust on the surface to be pasted. Oil stains and stains should be removed with a soft cloth dipped in degreasing solvent or cleaning agent, and then pasted after drying. For the parts where the paint has been soft, rusted or warped, this part of the paint should be removed, the part should be polished with sandpaper and rust-proof treatment, and then the car body reflective logo should be pasted.
●Basic Pasting Requirements
The reflective mark on the rear of the vehicle body should start with the white unit and end with the white unit. The side can start with a red unit, but the last unit near the rear of the vehicle should be a white unit.
After pasting the reflective mark on the vehicle body, it shall not affect the performance of the vehicle lighting and signal devices specified in this standard.
After pasting the reflective mark on the vehicle body, no drilling or slotting on the reflective mark on the vehicle body shall be allowed.
When the car body surface cannot be directly pasted with the car body reflective logo, the car body reflective logo should be pasted on a strip liner with certain rigidity, strength and anti-aging, and then the strip liner should be firmly pasted or riveted to the car body.
The minimum height of the reflective mark on the vehicle body from the ground is 380 mm.
